Odalog® Type L2

Odalog® Type L2

Simple and Effective Gas Monitoring

The OdaLog® has been specifically designed to withstand harsh environments typically found in the Wastewater Industry.

The OdaLog® is primarily used by locating it at or close to the source of Hydrogen Sulphide emissions such as within sewerage pumping stations and receiving manholes.

Its purpose is to monitor gas levels to help control H2S gas in sewerage systems and treatment plants for later review and evaluation using OdaStat-G software.

Gas monitoring in manholes, drains and pits
Odour monitoring in sewer and streaming water
Ventilation pipes and rising mains
Inside sewer collection lines
Selected areas in treatment plants
Asset management and odour control

Share this Post

Battery Life - Up to
Data Points
Of the time

You may also be interested in the following products

Gas Dilution System (GDS)

The Gas Dilution System (GDS) is an easy to use electronic device designed to take a known calibration gas or gas sample and dilute it to lower concentrations. The diluted gas outp [...]

Dry Dock

The OdaLog Dry Dock reduces recovery time for the OdaLog L2 by half. OdaLog gas sensors absorb moisture at the same rate of recovery. The calculation for how long to 'dry' excess m [...]

OdaTrak 4-20mA adapter

The OdaTrak™ 4 to 20mA adapter was primarily designed as an interface between the OdaLog® gas Logger and industrial control systems for the purpose of continuous, real-time opti [...]

7000 MkII

The OdaLog® 7000 MkII multi-gas unit is based on the proven OdaLog® Logger design and had been designed to be a single gas monitor, or to monitor up to 6 gases depending on the c [...]



Looking for an industry leading H2S Data Logger?